Adjust Product Stop - Weber Geset 141 Original User Manual

Chapter 7 Adjustment and initial operation

Adjust product stop

If the label material was properly inserted for the product to be labeled, the product stop
can be adjusted. The product stop ensures a repeat accuracy position of the label on the
product. The printing of the label layout determines if the product is placed to the stop with
top or bottom end.
No.
1
2
3
Requirements
¥
Labeling station is turned off.
¥
One or more sample products.
¥
Labels are inserted correctly.
¥
3-roll system is correctly adjusted (s. from page 49)
Instructions
Please adjust the product stop as follows.
Step
1
2
3
4
Version: 30.01.15
Description
LOCK OF PRODUCT STOP
PRODUCT STOP
LABEL ZERO EDGE
Procedure
Place the product in the 3-rolls system. The pusher roller rests on the pro-
duct.
Loosen the interlock (Pos. 1, Fig. 7-6) and move the stop depending on the
label zero edge (Pos. 3, Fig. 7-6) in required position.
Move the product to the stop (Pos. 2, Fig. 7-6)
Lock this adjustment (note if applicable the scale value)
Page 51 of 97
Fig. 7-6: Example figure for adjustment of product stop
40020664 Geset 141
GB