Table of Contents
Advertisement
Chapter 2 Safety regulations
Warnings on the labeling station
Special hazards arising from the labeling system are identified with yellow stickers. The
pictograms indicate hazards:
Remaining risks
The labeler is constructed in a way that makes it safe for use. Some hazards are inherent
in the design and construction but can be minimized with the corresponding safety mech-
anisms and equipment. A certain residual risk always exists when operating machinery.
Knowledge about residual risks of the system helps you to increase your safety aware-
ness and avoid accidents. To prevent hazards, observe the special safety instructions and
each chapter. When connecting the labeler to the customer's conveying system, there
may arise hazard areas at the transitions. Suitable protection measures have to be ar-
ranged in this case.
Safety instructions
Version: 30.01.15
Danger
Life-threatening hazard due to electrical power
Crushing hazard
Entanglement hazard
Observe manual
Hazard from direct or indirect contact with voltage-
conducting parts.
DANGER TO LIFE!
When individuals touch parts that conduct electricity arising from
malfunctions.
- Only electricians may work on the switch cabinet and electri-
cal equipment.
- Regularly check the electrical equipment of the labeling sys-
tem. Immediately take care of loose connections and dam-
aged cables.
- Always keep the switch cabinet locked.
- Before working on electrical equipment, switch the miniature
circuit breaker to "0" position and secure it against being ac-
cidentally turned on. If possible, disconnect the power.
Page 16 of 97
40020664 Geset 141
GB
Advertisement
Table of Contents
