000 Password; 101 Label Length (Label Len.) - Weber Geset 141 Original User Manual

Chapter 8 Operation

000 PASSWORD

If a configuration parameter is called up for editing by [Enter], you will have to enter a
password in order to grant access only to authorized persons.
The code is "123", the access is valid for all parameters, but only as long as you do not
push 2 times the [Stop]-button or switch off and on the labeler.
CONFIGURATION
PASSWORD:

Press either [] or [] to increase or reduce the value.

Press [Enter] to confirm the password entry.
- If password is correct you will return to configuration-parameter.
- If password is incorrect, "PASSWORD INCORRECT

Press [Start] or [Stop] to exit the parameter setting.

101 LABEL LENGTH (LABEL LEN.)

Herewith the label length (label length with a gap) is manually adjusted. The adjustment
range is 0 – 255,9 cm. This value is automatically detected with the calibration function
(see p. 48).
CONFIGURATION
LABEL LENGTH CM:

[Stop]. Press [Enter] to change the configuration parameter.

Press either [] or []to increase or reduce the value.

Press [Enter] to change to decimal place or to confirm the entry.

Press [Start] or [Stop] to exit the parameter setting.
Version: 30.01.15
101
000
001
4,2
Page 66 of 97
40020664 Geset 141
E15"will appear.
GB