Table of Contents
Advertisement
Chapter 6 Installation and initial startup
3
4
5
6
(X6) Alarm lamp (Option)
The connection of the optional alarm lamp is arranged by a M12, 8-pin plug.
Please note the warnings with the appropriate meanings as follows.
Fig. 6-7 Signal lamp
USB connection (Option)
Fig. 6-8: USB connection
Version: 30.01.15
Turn the headlights adjustment clockwise appr. 1 rotation until the label roll is
safely detected by the sensor. Observe that no objects are detected in the
background by the sensor.
Loosen the adjustment screws (Pos. 1, Fig. 6-6) with the hexagon socket
wrench.
Adjust the sensor so that the light beam of the sensor detects the label roll's
end. The farther you move the sensor to the roll's beginning, the earlier the
low label prewarning is carried out.
Tighten again the screw for adjustment (Pos. 1, Fig. 6-6) clockwise.
Light
Red
(continuous
light)
Yellow
(continuous
light)
Green
(continuous
light)
The labeling station can optionally be equipped with an USB 2.0
connection. The labeling station will be programmed and oper-
ated with software and PC. Additionally extensive diagnosis and
error detections can be evaluated.
Page 40 of 97
Meaning
Appears when the machine is in error condition
(READY-Signal is reset). Possible causes: low
label or applicator failure.
Appears at low label or low ribbon warning.
Appears when the machine is in operating mode
(READY-Signal is true).
40020664 Geset 141
GB
Advertisement
Table of Contents
