Event-Counter(Event-Counter) - Weber Geset 141 Original User Manual

Chapter 8 Operation

EVENT-COUNTER(EVENT-COUNTER)

Using this function a number of different event counters can be called up. These provide
useful statistic information about the events which are counted automatically during label-
ing operation.
Event
E00
E01 E22
to
EV1
EV2
EV3
EV4
EV5
* All counter values are stored in the memory of the labeler. The time at which to store the counter reading happens during a failure
or in stand-by mode. This means if the system is switched off in "READY"-Mode, the counter reading of EV1-EV5 can differ ex-
FUNCTIONS-MENU
EVENT-COUNTER

Push the *buttons [] or [] to change to the next parameter.

Push [Enter] to get to the event counters.
E00=00000
E01=00000
.
.
E22=00000
EV5=00000
EV1=00000000
.

Push the buttons [] or [] to get to the next event counter.

Push [Start] or [Stop] to exit the parameter settings.
Version: 30.01.15
Counter Information
Number of all stopped applying cycles without failures
Number of failures of the certain error code
*Number of printed labels
*Number of all extension movements of the cylinder.
*Number of blow off events
*Number of all communication failures (incl. autom. restored failures)
*Maintenance counter increases by 1 after the completion of 256 applying cycles
5-digit counter,
maximum value = 65535
(afterwards begin with 00000)
8-digit counter
Maximum value: 99999999
(afterwards begin with 00000000)
Page 63 of 97
40020664 Geset 141
tremely from the actual counted values.
GB