Table of Contents
Advertisement
Chapter 10 Troubleshooting
10. Troubleshooting
Safety instructions
Error description
This chapter is divided into 2 parts; "Mechanic Failures" and "Messages by Display".The
possible causes and their elimination is explained in the following two sequences.
Mechanic errors
Problem
Label liner tears
Label placement on the prod-
uct is consistently poor.
Version: 30.01.15
Hazard from direct or indirect contact with voltage-
conducting parts.
DANGER TO LIFE!
When individuals touch parts that conduct electricity arising from
malfunctions.
- Disconnect the labeler from power supply voltage before start-
ing any work at electrical equipment.
Hazard from rotating elements.
ENTANGLEMENT HAZARD!
Rotating elements at the labeler like label liner rewinder, web brake
and rollers of the drive unit are powered by motors.
-
Do not grip in, at or between the moving parts.
Possible cause
Damage of label roll:
Nicks or label cutter-die
damage on liner.
Dents/damages at the
side of the label roll.
Liner width varies signifi-
cantly.
Label web is not loaded cor-
rectly.
Adhesive residues in the area
of the peeler bar.
Slip due to dirt or wear.
Label with not suitable adhe-
sive, insufficient initial adhe-
sion.
Page 92 of 97
40020664 Geset 141
Solution
Exchange label roll.
Load label web correctly.
Remove adhesive residues and
check the label roll for damages
caused by adhesive residues.
Otherwise exchange roll.
Clean the drive rollers, check
them for wear. Replace them if
applicable or inquire Service-
Technician by Hotline (s. page
7).
Change label quality.
GB
Advertisement
Table of Contents
