Chapter 6 Installation and initial startup
Connection to supply voltage
Requirements
¥
Power supply according to "Specifications" is installed close (max. 1,5 m away)
to the labeling site
¥
Power switch is OFF (in "0"-position)
¥
Power voltage cable is available
Instruction
The labeler is connected to supply voltage as follows .
Step
1
2
3
4
Version: 30.01.15
Procedure
Connect the power voltage cable with the power socket.
Turn on the main switch.
Turn on the machine and control the running directions of the drives. If the
drives run against the intended driving direction, turn off the system immedi-
ately. The electrical rotating field must be changed in this case by an Electri-
cian.
Stop the labeling station and turn off the main switch.
Page 33 of 97
40020664 Geset 141
GB