Advertisement
Available languages
Available languages
LED STATUS
GREEN: O.K.
Flashing:
Standby
YELLOW: Printstop
Flashing:
Read/Write USB-
data transfer
RED:
Failure print head
not identified
Flashing:
If the text
selection is
confirmed by
pressing the ON-
/OFF-BUTTON
Flashing:
Fast = USB failure
LED SENSOR
GREEN: Print
YELLOW: Photo sensor
activation without
data
RED:
No shaft encoder
signal
Flashing:
Shaft encoder too
fast
OFF:
No print signal
LED INK
GREEN: O.K.
YELLOW: Ink below 5%
RED:
Ink empty
OFF:
No cartridge
LED NETWORK
GREEN: Connected
YELLOW: Network activation
RED:
Network failure
OFF:
No network
connected
QUICKGUIDE X1JET HP
Short: Print start / Print stop
Short: Text selection confirmation
Long: (>10 Sek.) Standby-mode
Short: Switch on the Off Standby-
SELECTION-BUTTON
1 x short: Selection print image 1
2 x short: Selection print image 2
3 x short: Selection print image 3
...
9 x short: Selection print image 9
Confirm the text selection within 5
sec.by a short pressing the ON-
/OFF-BUTTON
Up to 9 print images can be saved.
If more often pressed than print
images are in the memory, the last
print image in the memory will be
selected.
increases the start delay +1mm
decreases the start delay -1mm
Short: Test print (The last loaded
Long: (>5 sec.) Reset ink level
5 / 12
OPERATION
ON-/OFF-BUTTON
mode
ON-/OFF-BUTTON
+
INK-BUTTON
activate the purge process
SELECTION-BUTTON
+ ON/OFF-BUTTON
SELECTION-BUTTON
+ INK-BUTTON
INK-BUTTON
image will be print once)
INK_BUTTON
+
ON-/OFF-BUTTON
activate the purge process
Fig. 3.2
Advertisement
