Table of Contents
Advertisement
Chapter 8 Operation
Overview chart
ALPHA.04
STAND BY
PROGRAMMING 016
PARAMETER VALUE 123
PROGRAMMING 017
PARAMETER VALUE 123
PROGRAMMING 018
PROGRAMMING 255
PROGRAMMING 000
PROGRAMMING 001
PROGRAMMING 015
PARAMETER VALUE 123
PASSWORD
If in programming a parameter is called up with [Enter] in order to change it, the machine
asks for a PASSWORD to proceed, in order to limit access only to authorized personnel.
The access code is "01234", once correctly entered it remains valid until the machine is
switched off or reset by pressing [Stop] key two times.
PROGRAMMING
PASSWORD:
Press the [Enter] key to edit the fore digits resp. press again [Enter] to change to
the last digits. Press either [] or [] key* in order to increase or reduce the val-
ue (corresponding cursor is flashing)
Press [Enter] to confirm your input
With the valid password you will return to the configuration parameter.
With the invalid password appears "WRONG PASSWORD E15" in display
To exit settings, press the [Stop] key (for stand-by)
Version: 30.01.15
0000
.
.
.
.
xxx
Page 84 of 97
00000
40020664 Geset 141
PROGRAMMING
SEND CONFIG
PROGRAMMING
RECEIVE CONFIG.
PROGRAMMING
RESET PARAMETER
PROGRAMMING
STORE PARAM.
GB
Advertisement
Table of Contents
