Adjust Labeler To Label Roll Width - Weber Geset 141 Original User Manual

Chapter 7 Adjustment and initial operation

Adjust labeler to label roll width

The labeler has to be adapted to the guiding of the web brake and to the dancer arm of
the unwinding in the label roll's width. For adjustment, only the guide ring (Pos. 1, Fig. 7-1)
and the adjusting ring (Pos. 2, Fig. 7-1) are moved. The position of the label web to the
cabinet's side is adjusted ex-factory. The adjustment is arranged to „label roll width plus 2
mm".
No.
1
2
Requirement

Power supply is off (in „0"-position).

Label roll
Required equipment

Hexagon socket wrench
Instruction
Please adjust the labeler to the label roll's width as follows.
Step
1
2
3
Version: 30.01.15
Description
GUIDE RING
ADJUSTING RING
Procedure
Move the outer guide ring by means of the label material to the required
criteria (s. section above).
Loosen the setscrew at adjusting ring and adjust it with label material onto
the required criteria (s. section above).
Tighten again the setscrew.
Page 46 of 97
40020664 Geset 141
Fig. 7-1 Adjust labeler to label roll width
GB