Table of Contents
Advertisement
Chapter 6 Installation and initial startup
Installation
Continuous operation with minimal wear and downtime can only be ensured when the
system is installed properly. Fine adjustments to the conditions of use are essential when
installing the system. These fine adjustments are adapted to the surrounding conditions.
To make these fine adjustments, detailed professional knowledge is necessary that arises
from experience with labeling systems.
This required professional knowledge cannot be completely communicated by the operat-
ing instructions; therefore a Technician from the Bluhm Weber Group needs to perform
the installation or accept the labeling system in a final inspection. The warranty does not
cover damage or consequential damage arising from improper installation lacking the
necessary fine adjustments.
Requirements to the installation site
¥
An enclosed and clean room.
¥
Flat, solid base, any unevenness may not exceed 5 mm when stands from the
Bluhm Weber Group are used.
¥
Sufficient bearing capacity: 1,500 kg/m².
¥
Low vibration environment.
¥
Sufficient lighting: 500 Lx.
¥
No direct exposure to sunlight or a radiator.
¥
The machine may not be operated within electrostatic or magnetic fields. This
can cause the controls to malfunction.
¥
A proper energy supply (electricity and compressed air) according to the chapter,
"Specifications" on page 22.
Placing the labeling system
¥
The labeling machine is designed for a table workplace. It has to be adapted to
the operator under ergonomic aspects.
¥
The installed position must allow sufficient access for users and Service Techni-
cians. In particular at all times, the mains switch / plug must be freely accessible
to disconnect the power supply.
¥
Make sure that all fasteners are sufficiently tight.
¥
Observe all of the items under "Intended use" in the chapter "Safety regulations"
on page 13.
Version: 30.01.15
Page 30 of 97
40020664 Geset 141
GB
Advertisement
Table of Contents
