Table of Contents
Advertisement
Chapter 8 Operation
104 LABEL OPTIONS (LABEL OPTIONS)
These parameter can select functions that concern the label feed. If different functions
should be combined, it is possible by addition of the single values.
Example: doubled delay (brake ramp) and SE-function should be enabled. Please genera-
te the arithmetic sum (of 004 + 064) and enter the parameter value = "068".
CONFIGURATION
LABEL OPTIONS:
Press [Enter] to edit the configuration parameter.
Press either [] or []to increase or reduce the value.
Press [Enter] to confirm the entry.
Press [Start] or [Stop] to exit the parameter setting.
Parameter Function
(Default) Acceleration- and brake ramp 2G is selected (s. page 99).
000
+1
Acceleration- and brake ramp 3G is selected (s. page 99).
Acceleration- and brake ramp 4G is selected (s. page 99).
+2
+3
Acceleration- and brake ramp 5G is selected (s. page 99).
+4
Doubles the delay for abbreviation of the brake ramp.
* selects the pneumatic peeler blade.
+32
+64
Enables the shaft encoder input for automatic regulation of the label feed speed.
Adjusts the label sensor to trailing edge, i.e. the rear edge is used as reference
+128
edge. (Useful with detection problems with critical labels (e.g. label form ...).
*If the parameter +32 pneumatic peeler blade is selected, triggering occurs at the abate-
ment of the pneumatic peeler blade. After that the label is applied. The time of applying
the label can be set by parameter TRIGGER DELAY (TRIGGER DELAY) (see page 72).
Default parameter is 4+32=36.
For some applications it is reasonable when label application and abatement of pneumatic
peeler blade occur at the same time. In this case parameter +32 is not selected.
The duration of abatement of the pneumatic peeler blade has to be set with parameter
SYNC-PULSE-TIME (SYNC PULSE TIME) (see page 73).
Version: 30.01.15
104
094
Page 69 of 97
40020664 Geset 141
GB
Advertisement
Table of Contents
