Label Loading - Weber Geset 141 Original User Manual

Chapter 7 Adjustment and initial operation

Label loading

Requirement

Power supply is off (in „0"-Position).
Instruction
Please insert the label web as follows.
Step
1
2
3
4
5
6
7
8
9
10
11
12
Version: 30.01.15
Procedure
Open the clamp lever of the unwind disc and take it off. If there is still a label
roll at the unwind mandrel remove it.
Please put the label roll onto the adapter ring (round aluminium ring) and the
unwind core. If applicable fix the unwind core centered to the axis and fix it.
Put the unwinder disc again at the unwind axis and fix it with the clamping
lever.
Put the label web around the deflection roller.
Guide the label web around the dancer arm. Loosen the brake belt at unwin-
der by pushing the dancer arm.
Guide the label web according to the following figures (Fig. 7-2) through the
guiding plate and through the opening of the label sensor to peeler plate
and put it around the peeler plate.
The loading diagram sticks at the labeler.
Remove all labels from label liner from the peeler plate on.
Guide the label web according to the figures (Fig. 7-2) over the friction roller
and the dancer arm to the rewinder.
The rewinder axis has a free-wheeling that avoids the unwinding of the liner
material. By violent turning counter the rewind direction the free-wheeling
can be damaged.
Wrap the backing paper onto the rewinder's axis by means of the hook.
Turn the rewinder axis until the backing paper is pulled straight between
peeler plate and rewinder.
Adjust the web brake to a low brake power.
Make sure that the label web runs from the peeler plate to the rewinder in a
straight line.
Page 47 of 97
40020664 Geset 141
Fig. 7-2: Alpha Compact LH
GB