108 Trigger Delay (Trigger Delay); 109 Trigger Blank (Trigger Blank) - Weber Geset 141 Original User Manual

Chapter 8 Operation

108 TRIGGER DELAY (TRIGGER DELAY)

With this parameter, the labeling procedure may be delayed. From trigger event on the la-
bel will be applied onto the product according to the set distance (value x 1 mm) shifted.
The set value is valid for each label speed. The delay may be from 0 to appr.255 mm.
A higher value also increases the stopping time of the driven roller in the 3-roller system;
for safe pressing of the label on the product.
CONFIGURATION
TRIGGER DELAY

Press [Enter] to edit the configuration parameter.

Press the *buttons [] or [] to increase or reduce the value.

Press [Enter] to confirm the entry

Press [Start] or [Stop] to exit the parameter setting.

Is the rate of application not reached, the delay settings are too high. Set the
sensor close to the labeler for getting a low delay and a high clock speed.

109 TRIGGER BLANK (TRIGGER BLANK)

This parameter is used for debouncing of sensor input i.e. after a trigger event, subse-
quent trigger signals are ignored. This setting is particularly useful for products with irregu-
lar shapes or foil packagings that may lead to multiple triggerings. Incoming trigger pulses
are skipped for the here adjusted length (value x 1mm).
If in parameter „106 LABELS PER TRIG". More than one label per triggering was select-
ed, with parameter 109 IGN TRIGGER the distance between the single label applications
is adjusted.
If a shaft encoder is connected, the adjustment is arranged in millimeters. If there is no
shaft encoder connected, the adjustment is arranged in milliseconds.
CONFIGURATION
TRIGGER BLANK MM:

Press [Enter] to edit the configuration parameter.

Press either [] or []to increase or reduce the value.

Press [Enter] to confirm the entry

Press [Start] or [Stop] to exit the parameter setting.
Version: 30.01.15
108
001
109
000
Page 72 of 97
40020664 Geset 141
GB