Connecting The Labeling Station; Connection To Supply Voltage - Weber Geset 111 Original User Manual

Chapter 6 Installation and initial startup

Connecting the labeling station

The labeling station requires electricity to work. For details see the chapter:
"Specifications" on page 21.

Connection to supply voltage

Requirements

Power supply is installed close to or (max. 1,5 m distant) from the labeling site (s.
Chapter: "Specifications " on page 21).

Main switch is in OFF/ 0-position

Power cabling is available
Instruction
Please connect the labeling system with the power supply as follows.
Step
1
2
3
4
Version: 12.05.14
Procedure
Connect the power voltage cable with the power socket.
Risk of injury from pulling in and crushing!
Immediately after turning on, several system parts make a reference run or
move to its home position!
Maintain a distance from powered system components.
Turn on the frequency converter.
Turn on the machine and control the running directions of the drives. If the
drives run against the intended driving direction, turn off the system
immediately. The electrical rotating field must be changed in this case by an
Electrician.
Stop the labeling station and turn off the frequency converter.
Page 30 of 56
40001684 Geset 111
GB