Table of Contents
Advertisement
Chapter 8 - Workstation Software
To record a cine-loop sequence:
STEP 1
STEP 2
STEP 3
Figure 8-8: Use the cine mode to record video clips
STEP 4
STEP 5
STEP 6
Like images, you can choose whether to save a cine-loop sequence to the
study, or discard them.
94
Press
.
From Exposure Mode, select CINE.
Create a new study and initiate fluoroscopic imaging.
The cine-loop sequence will be recorded and automatically played
on the control screen. The AP and LT cine-loop sequences (1 & 2) are
juxtaposed, as shown in the figure below:
Play the cine-loop sequences using the controls underneath, which
are shown in Figure 8-8 (p100), as described below:
8
Jump backwards by 10 frames
9
Jump backwards by 1 frame
10
Start or stop the playback
11
Jump forwards by 1 frame
12
Jump forwards by 10 frames
Drag the slider on the progress bar to browse the video content.
Move the two sliders below the progress bar to set the play range.
The slider controls are shown in Figure 8-8 (p100) and are described
below:
3
Slider that sets the current playback position
4
Start of the loop
5
The current frame
6
End of the loop
Press the Reset button (7) to reset the loop range settings (the two
sliders beneath the progress bar returning to their original position).
Cine-loop (Optional)
B6 User Manual
Advertisement
Table of Contents
