Table of Contents
Advertisement
Transport and Storage Environment
12.1
Transport and Storage Environment
Use special equipment package for the outdoor transportation of this unit.
CAUTION
Do not put this unit to a place where the temperature tends to change rap-
idly and drastically.
The G-Arm system is not allowed to be stored or transported in the environ-
ments that do not match the following conditions:
Temperature:
Relative Humidity:
Barometric:
CAUTION
CAUTION
12.2
Related Symbols
The following table lists the symbols used on the transport package:
XGB6-12-1014, Rev 1.04
Take extra care when moving the G-Arm system across uneven
ground. For example, when getting in/out of elevators, move the
equipment as gently as possible to protect the precision components,
like the image intensifiers and the CCD cameras, from being damaged
by the violent vibration.
-20°C ~ 55°C
10% ~ 90% (Non-condensing)
700 hPa ~ 1060 hPa
At initial setup or when removing from storage, stabilize the equip-
ment at ambient temperature and humidity for 4 hours before apply-
ing power. Failure to observe this warning might damage the
equipment.
If the equipment has not been used for an extended amount of time
(over 30 days), turn it on and leave it idle without taking any exposures
for 2~3 hours in order to maintain the required vacuum in the image
intensifier.
Chapter 12 - Transport and Storage
147
Advertisement
Table of Contents
