Table of Contents
Advertisement
Chapter 8 - Workstation Software
To create a study using the patient information from the worklist:
STEP 1
STEP 2
CAUTION
90
Figure 8-5: Select a patient from the worklist
Press
, and then switch to the Worklist tab.
The Worklist tab is displayed, as shown in Figure 8-5 (p96).
On the Worklist tab, click or tap to select a patient, and then press
Register.
The G-Arm system creates a new study for the selected patient, and
gets ready for fluoroscopic imaging.
Before you are able to use the worklist to retrieve patient list from other
information systems, you need to set up a DICOM service that estab-
lishes communications with other systems and have it properly
mapped to the worklist feature of the G-Arm system. Refer to "DICOM
Setup" (s8.17, p124) for instructions on this topic.
Registering Patients
B6 User Manual
Advertisement
Table of Contents
