Table of Contents
Advertisement
Chapter 3 - System Components
STEP 2
STEP 3
STEP 4
CAUTION
3.5
Skin Spacer (Optional)
A skin spacer component may come with the G-Arm system to keep the
body surface of the patient far enough from the X-ray emitting window of
the LT tube assembly.
To install the skin spacer:
STEP
CAUTION
34
Turn on the other set of laser lights if necessary.
Adjust the G-Arm or the operating table until the cross marks are lo-
cated over the desired region of interest.
Press the power switch(es) again to turn off the laser light indicators.
The laster light indicator is class 2 laser product. Beware of laser radia-
tion. Do not stare into beam.
Maximum Output: ≤ 1 mW
Wave Length: 635 nM
Figure 3-4: Skin Spacer
1
Skin Spacer
Fasten the skin spacer onto the X-ray emitting window of the LT
tube assembly using the 4 plastic screws with your fingers.
Do not use screw drivers to fasten these screws. Use your fingers only.
2
Screw
Skin Spacer (Optional)
B6 User Manual
Advertisement
Table of Contents
