Table of Contents
Advertisement
Printing Images
Print layout
There are four layouts provided for printing (row × column):
●
1 × 1
●
1 × 2
●
2 × 1
●
2 × 2
Technique for rearranging images
The G-Arm workstation software does not provide an intuitive method for
you to move the images around in the layout. If you are not satisfied with the
order in which the images are displayed, you can rearrange the images by re-
moving all the images and then add them back again in the order you want.
If the order is rather different from the current one, you are recommended
to clear and add all the images again:
STEP
However, you can use the following technique to rearrange the layout if only
one or two images need to be re-arranged:
STEP 1
STEP 2
Show ROI in a image
You can enlarge the images in the layout to show a more detailed portion of
the image with smaller field of view (FoV). You can also drag and move the
enlarged image to change the region of interest (ROI) in the layout frame,
which acts more like a view port now.
To show a more detailed portion of an image:
STEP 1
STEP 2
STEP 3
XGB6-12-1014, Rev 1.04
Press Delete All and re-add images in the order you want.
Select that image, press Delete.
Each image after that image will move one frame forward to fill the
blank frame left by the deleted image.
Click Back and re-add that image to the layout.
That image will be added to the last frame of the layout (the lower-
right frame for the 2 × 2 layout).
Select an image.
Drag the slider on the Enlarge control
Note: You can also directly click or tap on the sliding bar to move the
slider to that position.
Click or tap inside the selected image and hold down the left button
or finger to drag the image around. Repeat this until the ROI is dis-
played in the frame.
Chapter 8 - Workstation Software
to the right.
109
Advertisement
Table of Contents
