Control Panel And Bullnose Removal And Replacement - Thermador PRL304EG Service Manual

Service Manual for Thermador Pro Grand LP Gas Ranges, Models: PRL304EG, PRL364EDG, PRL364ELG, PRL366EG, PRL484ECG, PRL486EDG, PRL486EDPG, PRL484ELG
Figure 129: Removing the Thermostat Bulb from Retaining Bracket
1 Retaining bracket
2 Thermostat bulb
Figure 130: Screws on Bezel of Griddle Thermostat
1 Screw locations (2)
58300000156573_ARA_EN_B

4.5.26 Control Panel and Bullnose Removal and Replacement

Figure 131: Bullnose and Control Panel (Shown with Knobs Removed)
Access to the control panel and bullnose is from the top and front of
the range.
This procedure is provided primarily in the event the control panel is
damaged and needs replacing. Most components can be accessed
and serviced without the need to remove the control panel.
Be sure to check QuickFinder for relevant information, documentation,
and the correct part number when replacing this component.
1. Follow all safety precautions and steps in Preparing the Range for
Servicing, page 21.
2. Follow all steps in Accessing Components under the Maintop,
page 21.
3. From the back of the control panel, first make a note of how the
wires are connected, and then detach only the wire connectors for
all the LED indicators, as well as the wire connector for the
temperature gauge. You do not have to detach the wire
connectors for other knob components.
NOTE: It is always recommended to label and tag all wires, wire
connectors and harnesses prior to disconnecting them, so as to
correctly identify their connections/locations when re-assembling.
Alternatively, you can photograph the wire connections prior to
disconnecting (for example, with your mobile phone).
NOTE: LED indicators can stay on control panel as long as their
connectors are detached.
4. Remove all knobs from the control panel.
Page 69 of 119