Grill Thermostat Bulb Removal And Replacement - Thermador PRL304EG Service Manual

Service Manual for Thermador Pro Grand LP Gas Ranges, Models: PRL304EG, PRL364EDG, PRL364ELG, PRL366EG, PRL484ECG, PRL486EDG, PRL486EDPG, PRL484ELG
4.4.5

Grill Thermostat Bulb Removal and Replacement

The removal and replacement of the grill thermostat requires
removing the bulb from the burner box (per this procedure). It also
requires removal of the thermostat switch at the control panel (see
Griddle / Grill Thermostat Removal and Replacement, page 68).
12. Remove and retain the screw that secures the side panel of the
burner box, and then remove the side panel. The left side panel
acts as a shield for the sensor bulb. See Figure 64 and Figure 65.
Figure 64: Left Side Panel of Grill Burner Box (Shown Attached)
1 Screw securing side panel onto burner box
2 Left side panel of burner box
13. Gently remove the sensor bulb by sliding it out of the bracket (the
bracket does not have to be removed). See Figure 65.
58300000156573_ARA_EN_B
Figure 65: Thermostat Sensor Bulb (Shown with Left Side Panel of
Burner Box Removed)
1 Bracket
2 Sensor bulb
3 Capillary tube
4 Portal for sensor bulb
m
Caution
You can extend the capillary tube of the thermostat to the needed
length, however be careful not to twist or bend it, or it may impede
the component's ability to operate properly.
14. Carefully slide the sensor bulb and capillary tube through the
portal in the burner box chassis (see Figure 65).
15. If you have not already done so prior, detach the thermostat
switch from the control panel (see Griddle / Grill Thermostat
Removal and Replacement, page 68), and then remove the grill
thermostat assembly from the range.
Page 36 of 119