Table of Contents
Advertisement
Port Set up
<Default> vs. Individual Port Settings
Introduction
The PBXgateway II provides voice connectivity for up to 24 remote users. All
phone ports on the PBXgateway II are cross-wired to a digital port on the PBX.
This provides the remote user with full PBX functionality as if they were placing
calls from the corporate office. The EXTender 6000 unit is connected to the
remote phones through an RJ-21 connector wired to a punch down block or wall
field.
Once the units are connected (see Port Set up on page 76) the Management
Interface (MI) has two methods for setting up the PBXgateway II ports:
<Default>
The <Default> settings: Sets all ports identically. With <Default> selected for a
settings vs.
specific parameter for any port, that parameter will be set to whatever value the
individual
Port-><Default> parameter is set to.
settings
Example: If the Port-><Default> value for "Voice method" is set to ADPCM
32, and Port 1 has <Default> selected for "Voice Method" then Port 1 will utilize
ADPCM 32 for its voice compression.
Individual port settings: Sets each port individually. This method is used for
customizing ports by providing the flexibility of changing parameters for specific
users.
Example: If Port 1 has the "Voice method" set to G.729A, rather than the
<Default>, Port 1 will utilize G.729A for its voice compression.
PBXgateway II System Administrator's Guide
76
Advertisement
Table of Contents
