IP Parameters
IP Address Parameters
An Internet Protocol (IP) address and associated routing parameters must be entered within the
IP menu to locate the PBXgateway II on the LAN (Local Area Network) over an IP connection.
This is required to manage the PBXgateway II using Telnet or to configure the PBXgateway II to
use RVP_IP.
Note: The IP address (as well as any required mask or router addresses) must be provided by
the network administrator.
The following IP settings are required:
Settings
•
Web Server – This parameter Enables or Disables configuration of the
PBXgateway II via a web browser.
•
Address- This is the IP address which identifies the PBXgateway II on the
LAN.
•
Subnet Mask – A number used to identify the IP subnetwork on the LAN.
•
Default Router – The address of a device used to reach IP hosts not on this
IP subnetwork.
Procedure
1. Access the LAN menu using the following path:
Path:
->Configuration->IP->LAN (or AUX_LAN)
The following menu appears:
2. Press the ↓ key to access the Web Server parameter.
3. Press the → key to Enable or Disable the parameter.
4. Press the ← and ↓ key to the Save option.
5. Press Enter to save changes to the active config (.swt) file.
PBXgateway II System Administrator's Guide
Figure 28:
LAN Menu
89