Setting The Sync Rate; Setting The Async Parameters - MCK EXTender PBXgateway II System Administrator Manual

Setting the Sync Rate

Procedure
1. Access the WAN 1 or WAN 2 Menu using the following path:
Path:
->Configuration->WAN-> WAN 1 or WAN 2
2. Press the → key to access the parameters.
3. Press the → key to the Sync Rate parameter and type in the correct Sync rate. This parameter sets
the synchronous data transfer speed of the WAN port and must match the network device speed.
Note: This Sync Rate information, displayed in bytes, must be obtained through the network device
documentation and corresponds to network rate.
4. Press the ← key to accept changes and go back to the Configuration Menu.
5. Press the ↓ key to the Save parameter.
6. Press Enter to save changes to the active config (.swt) file.

Setting the Async Parameters

Procedure
1. Access the WAN 1 or WAN 2 Menu using the following path;
Path:
Gateway->Configuration->WAN 1 or 2->Async_Setup
2. The following menu appears. Press the → key to access the parameters
Press the → key to the DCE Type parameter. Press the → key to select the network device being
3.
used. A list of recommended devices is in the table below.
MFG
3 Com
Adtran
PBXgateway II System Administrator's Guide
Figure 27:
Model(s) (see note)
3 Com U.S. Robotics
ISU 2X64
ISU 128
Express NTU
Express 3000
Async_Setup Menu
86