Table of Contents
Advertisement
Parameter Location:
DTMF
Configuration->Port->Voice
Description: DTMF is a signal generated by pressing numbers on the keypad of
a phone. These tones can be sent across the network and received at the
alternate unit as an in-band (voice) signal. The in-band signal is generated by the
DEFINITY ECS or remote phone.
If the DTMF tone is sent out-of-band (signaling) the DSP on the alternate unit
generates the tone. Enable/Disable sending Dual Tone Multi-Frequency (DTMF)
tones as voice (in-band) as opposed to signaling (out-of-band).
Usage: Out-of-band provides a clearer tone for higher compression algorithms
(G.729A).
Dependencies: NA.
Parameter Location:
Dump All
Utilities->System
Description: This parameter will dump the entire configuration file to the screen
to allow a terminal program to capture the text.
Dependencies: A PC must be connected to the console port.
Usage: This provides an easy way to transfer the configuration file to a text file on
the PC.
Parameter Location:
Edit Config
Remote/Gateway->Utilities->File
Description: This is a file saved within the EXTender Flash file system, which
contains all configuration parameters. Use this command to create a new config
file.
Example: Runtime.rem (remote) or .swt (Gateway)
Dependencies: Must use the correct file type for the unit.
See Also: Editing Non-Active Configuration Files on page 159.
PBXgateway II System Administrator's Guide
126
Advertisement
Table of Contents
