Table of Contents
Advertisement
Console Setup Wizard
A console setup wizard has been created for the PBXgateway II and Branch Office EXTender 6000, and
a phone interface setup wizard has been created for the EXTender 4000. The setup wizard will guide a
user through most of the required programming and configuration required to complete the initial setup of
the units, via the VT100 management console accessed through the DB9 serial port on the PBXgateway
II. Parameters not configurable through the wizard can be set through the Management Interface.
When a unit is first powered up it will check a Setup Wizard flag. If the flag is set then the standard
console UI will be displayed. If the flag is not set then the user will be asked whether they would like to
run the Setup Wizard. After this initial prompt the Setup Wizard flag will be set, preventing the user from
being asked to run the Wizard again. The Setup Wizard can also be accessed through the console
Management Interface in case the user wants to run it later.
Portion of the variables configured through Setup Wizard:
Branch Office EXTender 6000
•
Choice of RVP or RVP_IP
•
IP Configuration
EXTender 4000 (setup wizard runs through phone interface)
•
Gateway port number
•
Gateway IP address
PBXgateway II
•
WAN cable type (RVP only)
•
Connection speed (RVP only)
•
IP Configuration
PBXgateway II System Administrator's Guide
116
Advertisement
Table of Contents
