Enabling/Disabling Wan Ports; Setting The Mode (Signaling Protocol) - MCK EXTender PBXgateway II System Administrator Manual

Enabling/Disabling WAN Ports

Procedure
1. Access the WAN 1 or WAN 2 Menu using the following path:
Path:
->Configuration->WAN-> WAN 1 or WAN 2
2. The following menu appears. Press the → key to access the Enabled parameter.
3. Press the → key to change the availability of the port to:
Enabled (Yes) or Disabled (No).
4. Press the ← key to accept changes and go back to the Configuration Menu.
5. Press the ↓ key to the Save parameter.
6. Press Enter to save changes to the active config (.swt) file.

Setting the Mode (signaling protocol)

Procedure
1. Access the WAN 1 or WAN 2 Menu using the following path:
Path:
Configuration->WAN-> WAN 1 or WAN
->
2. The WAN menu appears. Press the → key to access the parameters.
3. Press the ↓ key to the Mode parameter. This parameter must match the protocol (V.35, RS-530, or
RS-232) used by the network device connected to the WAN port. Press the → key to scroll through
the available protocols.
4. Press the ← key to accept changes and go back to the Configuration Menu.
5. Press the ↓ key to the Save parameter.
6. Press Enter to save changes to the active config (.swt) file.
PBXgateway II System Administrator's Guide
Figure 26: WAN Menu
2
85