Protocol (Wan); Reset Stats; Secondary Interface - MCK EXTender PBXgateway II System Administrator Manual

Parameter Location:
Protocol
Configuration->WAN->WAN_X
(WAN)
Description: Selects the method to bridge multiple protocols across the network.
Usage: Used when the Gateway functions as an Integrated Access Device (IAD).
Log messages include:
•
Fatal: Unit is not functioning
•
Error: Failure
•
Warning: Problem with unit, still operational
•
Info: EXTender session, someone connected
•
Debug: Detailed message (for troubleshooting)
•
Trace: Packet type tracing
Example: If the (Syslog) Priority was set to "Info", then the only log messages that
would NOT be saved are messages related to "Debug" and "Trace".
Parameter Location:

Reset Stats

Utilities->System
Description: Resets the WAN stats and Connect stats.
Usage: Used to clean up the statistics and to help pinpoint problems associated
with the unit.
Parameter Location:
Secondary
Configuration->Connect->RVP_Direct
Interface
Description: This parameter tells the PBXgateway II which Serial WAN port it
should try to use if the Primary Interface fails or runs out of bandwidth. The
Secondary Interface is used as a backup or network overflow of the Primary
Interface. If you do not have both WAN ports enabled, you do not need a

Secondary Interface.

Available Options:
None
WAN1
WAN2
Dependencies: The WAN port corresponding to this connection parameter must
be enabled and connected to appropriate network equipment.
See also: Primary Interface on page 131.
PBXgateway II System Administrator's Guide 133