Telnet/Ftp Setup; Enabling/Disabling Telnet; Enabling/Disabling Ftp - MCK EXTender PBXgateway II System Administrator Manual

Telnet/FTP Setup

The PBXgateway II can be configured through a Telnet session and files can be saved or
retrieved through an FTP session.
Telnet
By default, Telnet is Enabled. Disabling it will prevent anyone from accessing the unit through
Telnet.
FTP
By default, FTP is disabled. Disabling it will prevent anyone from saving files to or retrieving
files from the unit through FTP. This is normally done to upgrade the unit's software.

Enabling/Disabling Telnet

1. Access the IP Menu from the Main Menu using the following path:
Path:
->Configuration->IP->LAN (or AUX_LAN)
2. Press the ↓ key to the Telnet parameter.
3. Press the → key to toggle the Telnet parameter between Enabled and Disabled.
4. Press the ← key to go accept changes and go back to the Configuration Menu
Press the ↓ key to the Save option.
5.
6. Press Enter to save changes to the active config (.swt) file.

Enabling/Disabling FTP

1. Follow the same steps to get to the Telnet parameter.
2. Press the ↓ key to the FTP parameter.
3. Press the → key to toggle the FTP parameter between Enabled and Disabled.
4. Press the ← key to go accept changes and go back to the Configuration Menu
Press the ↓ key to the Save option.
5.
6. Press Enter to save changes to the active config (.swt) file.
PBXgateway II System Administrator's Guide 93