Table of Contents
Advertisement
Changing the Active Config file
Introduction
When the PBXgateway II is powered up, the Flash file system loads a
configuration file (called the "active" .rem (Remote) or .swt (Gateway) file) which
contains all the parameters necessary for operation. The system administrator
can change this "active" .rem (Remote) or .swt (Gateway) file so that a different
set of parameters loads.
Note: The default configuration file shipped with the units is runtime.rem or
runtime.swt.
Access the Config Menu using the following path:
Procedure
Path: Utilities->Upgrade>Config File
1. Select an existing .rem (Remote) or .swt (Gateway) file from the list
displayed.
2. The display reads;
Change Configuration file to..
Enter (Y) or (N).
3. The unit will then prompt you to reboot. This change requires a reboot in
order to take affect.
All changes made to the Gateway or Remote parameters will be saved under the
new config file.
Editing Non-Active Configuration Files
Introduction
The PBXgateway II can be used in different applications requiring different
parameters. The system administrator may need to set up separate
configuration files to accommodate custom parameters for each application.
The ability to modify any non-active configuration file, allows the system
administrator a method for quickly setting up new units based on existing
configuration parameters.
IMPORTANT NOTE: To edit the "active" config file, use the Configuration Menu
(see Chapter 4).
Access the Edit Configuration Menu using the following path:
Procedure
Path: Utilities->File>Edit Config
1. Choose Gateway or Remote and select a config file from the available files,
press Enter.
2. Modify the necessary parameters as required.
(Refer to Chapter 4 for more information)
3. As required, select Save and press Enter to save changes. The following
message appears:
Save changes to Filename _____.rem (Remote) or .swt (Gateway)?
PBXgateway II System Administrator's Guide
159
Advertisement
Table of Contents
