Table of Contents
Advertisement
MI Parameters
Parameter Location:
Address
Configuration->IP->LAN (or AUX_LAN)
->Address
(IP->LAN
->Address)
Description: The Internet Protocol (IP) Address
Usage: A 3-bit address used for IP connectivity. When assigned, the IP Address
identifies the PBXgateway II on the network.
Example: 193.245.101.67
Dependencies:
•
Must be assigned by the network administrator
•
IP Address is required for unit management and
•
RVP_IP connections.
•
Must be an assigned static (fixed) address
See Also: IP Address Parameters on page 89.
Parameter Location:
Async Rate
Configuration->WAN->WAN_X->Async_Setup
Description: The asynchronous data transfer rate.
Usage: This parameter identifies the asynchronous data transfer speed of the
WAN port. This value must match the network device speed.
Note: This Async Rate should be left at the <default> setting of 115200.
Dependencies: N/A
Parameter Location:
Auto
Remote>Configuration->Port->Default or Port x
Connect
Description: If Enabled, the phone ports automatically connect when the
PBXgateway II and Remote units are powered up. This feature also includes a
retry timer with backoff. This means that the unit will wait a few seconds between
retries and will only try and connect up to a minute before it stops.
Usage: No need to press "1" on Remote phone to connect.
Dependencies: Remote unit only
PBXgateway II System Administrator's Guide
122
Advertisement
Table of Contents
