Table of Contents
Advertisement
Network Environments
Introduction
This section of the manual provides the necessary information to configure the
PBXgateway II using the Management Interface (MI). The units are
programmed at the factory with "default" settings providing basic parameters to
accommodate most network environments.
Before beginning the configuration process, it is necessary to identify which type
Which type of
of network device is connected to the PBXgateway. Once you know the type of
Network
connection, the table below will direct you to the appropriate checklist that should
Device do
be used for configuration.
you have?
Note: See "What a System Administrator must know" on page 56 for more
information.
To configure the PBXgateway II with...
a Synchronous-Serial device (RVP_Direct)
a Asynchronous-Serial device (RVP_Direct)
an IP device (RVP_IP)
PBXgateway II System Administrator's Guide
See page
69
71
73
68
Advertisement
Table of Contents
