Table of Contents
Advertisement
Telnet Connection
The PBXgateway II can be configured using a Telnet session over the
Introduction
existing LAN connection. There is a maximum of four Telnet connections
per unit at one time.
IMPORTANT NOTE: All IP parameters must be configured before a Telnet
session can be established to a unit. (see page 89 for more information)
Procedure
1. On a computer running Windows, open the Telnet application by selecting Start/Run from the
desktop.
2. Enter telnet command along with the IP address assigned to the unit.
Figure 19:
Telnet Address
3. Click OK. The MI Welcome Screen appears (see the next page).
PBXgateway II System Administrator's Guide
62
Advertisement
Table of Contents
