WAN Port Set up
The PBXgateway II has two WAN ports (WAN 1 and WAN 2) used for synchronous or
asynchronous-serial connections. The ports communicate via an RS-232, RS-530 or V.35
interface and provide the connections to the third party network devices.
Note: Used for RVP_Direct only.
Settings
•
Note: It is recommended that you disable ports not in use
•
Synchronous-
Setting the Sync Rate – Sets the specific WAN port to the sync rate
Serial
(synchronous serial port transfer speed) of the network device (CSU/DSU).
Refer to page 86.
Setting the Async Parameters – Sets the required parameters to match the
Asynchronous
-Serial
specific asynchronous device connected to the WAN port. See page 86.
PBXgateway II System Administrator's Guide
Enabling/Disabling WAN ports- Individually Enable or Disable a specific
WAN port. Refer to page 85.
Setting the Interface Mode - Choose the interface signaling type
(synchronous or asynchronous) used to communicate with the network
device. Refer to page 85.
84