Table of Contents
Advertisement
Remote Access using a 3Com Modem
Introduction
The console port provides connectivity to a modem for remote configuration
of the PBXgateway II. This connection allows access to all features and
functions of the MI and the ability to configure, monitor and troubleshoot the
unit from a remote location.
Required Cable
RS-232, DB25 to DB9 modem cable [male-female]. Use this cable to
connect the modem to the console port on the front of the unit.
Before you
1. Setup the modem dip switches as required.
Connect
2. Connect the analog phone line to the modem.
3. Plug the modem cable (provided with the unit) into the back of the
4. Power-up the modem. The modem will run through a series of self-
5. Plug the other end of the modem cable into the port labeled "modem
6. Refer to ETI set up on page 61.
Table 4:
Modem Cable Pinouts
DB25 Male
Pin
Function
2
3
7
Common
PBXgateway II System Administrator's Guide
modem.
diagnostic tests.
port" on the front of the PBXgateway II.
DB9 Female
Pin
Tx
3
Rx
2
5
Function
Rx
Tx
Common
60
Advertisement
Table of Contents
