Table of Contents
Advertisement
Parameter Location:
Password(
Configuration->Port
Connect)
Description: A connect password provides a secure link between the
PBXgateway II and Remote Unit.
Usage: If assigned, the connect password must be entered for communication
between the PBXgateway II and a Remote unit.
Example: 427stamp
Dependencies: The connect passwords for both units must match.
See Also: Chapter 4, section Setting a Connect Password.
Parameter Location:
Path
Configuration->Port->Default->Voice
(Voice)
Description: Dynamic/Constant voice path following off-hook/on-hook.
Dynamic means that the Branch Office unit uses the available bandwidth when
the remote user goes off-hook.
Constant means that the voice path is always reserved.
Usage: Used for applications that are "oversubscribed" allowing the maximum
use of available bandwidth. If bandwidth is not available to a user and dynamic
voice path is enabled, they hear a "fast busy" and the call will be blocked.
Oversubscribed: Number of users exceeds available bandwidth.
Dependencies: PBXgateway II only.
Recommendations: Constant
Parameter Location:
Primary
Remote>Configuration>Connect->RVP_Direct
Interface
Description: This parameter tells the PBXgateway II which Serial WAN port it
should try to use in order to bring up phone connections and voice paths. Your
Primary Connection port must coincide with the WAN port that is enabled and
connected to an appropriate network device. In other words, if you select WAN
1 you must have WAN 1 enabled and connected to a network device.
Available Options:
WAN 1
WAN 2
Dependencies: EXTender 6000 remote units only.
The WAN port corresponding to this connection parameter must be enabled and
connected to appropriate network equipment.
See also: Secondary Interface on page 133
PBXgateway II System Administrator's Guide
131
Advertisement
Table of Contents
