Enabling Connex - MCK EXTender PBXgateway II System Administrator Manual

Enabling ConneX

The PBXgateway II supports the ConneX features. This application puts PBX features and dialtone in the
hands of users of remote telephones.
Note: If ADSI enabled phones are being used the user will have access to all the RemoteConneX
features. If Analog or mobile phones are being used by your remote workers the MobileConneX features
will be accessible to the user. The prompts for these applications are very similar but may differ in some
instances.
MCK's PBXgateway II is an application-specific gateway capable of extending dialtone and features of
the enterprise PBX to up to 24 users of ConneX Phones and/or mobile phones. ConneX features can be
enabled on a port by port basis.
Note: Setting the ConneX port values in the default port menu will assign these values, and the
associated ConneX features to all ports. If you wish to use a single port for ConneX then configure an
individual port.
Procedure
1. Access the port parameters using the following path:
Gateway->Configuration->Port -> Ports_x-y ->Ch 2 Mode
2. Set Ch 2 Mode to Voice.
3. The number of ports configured for ConneX usage will depend on the number of remote users.
Figure 46: ConneX – Default Port
PBXgateway II System Administrator's Guide 110