Micromeritics ASAP 2460 Operator's Manual page 307

ASAP 2460 Operator's Manual
4052- Fewer than two points are selected for this report.
Cause:
Action:
4053- At least two data points must be selected for t-Plot calculations.
Cause:
Action:
4054- Fewer than two data points are inside the fitted thickness range.
Cause:
Action A:
Action B:
4055- A positive BET surface area could not be calculated.
Cause:
Action A:
Action B:
4056- A positive Langmuir surface area could not be calculated.
Cause:
Action A:
Action B:
246-42800-01 - Dec 2013
At least two points are required for the BET calculations.
Edit the calculation assignments for the BET report.
At least two points are required for the t-Plot calculations.
Edit the calculation assignments for the t-Plot report.
At least two points must be within the fitted thickness range for the t-
Plot calculations.
Edit the calculation assignments for the t-Plot report.
Edit the fitted thickness range in the t-Plot report editor.
Fewer than two points were assigned to the requested surface area cal-
culation in the collected data table.
Assign more points to the surface area calculation.
Select a different surface area in the t-Plot report editor.
Fewer than two points were assigned to the requested surface area cal-
culation in the collected data table.
Assign more points to the surface area calculation.
Select a different surface area in the t-Plot report editor.
Appendix B
B-27