Automatic Operation; Memory Operation; Mdi Operation - Adtech ADTECH4 CNC Series Maintenance Manual

The machine tool moving according to prepared program is called as automatic operation. The automatic
operation modes of CNC46XX and 49XX system follow:
Memory operation, MDI operation, USB disk DNC operation

5.1 Memory Operation

The machine tool can operate according to the program in CNC46XX memory, which is called as
memory operation.
The program is pre-stored in the memory. Select and load a program with the operation panel and press
the "Start" key to start the automatic operation. Then, press "Pause" key to pause, press "Start" key again to
resume the operation, and press "Reset" during operation to stop the program immediately.
The step of memory operation follows:
(1) Save the program in the memory (see 8.1 for details);
(2) Select [Edit], [File] in the menu or press [File] on the panel to enter file operation interface;
(3) Press the direction keys to move the cursor, press [EOB] to select a program and load the file into the
work area;
(4) Press mode selection key [Auto] to switch to automatic mode;
(5) Press the [Start] key to run the program, and the indicator is on.

5.2 MDI Operation

In [Monitor] interface, switch to [MDI], enter the program with keypad and make the machine tool
operate according to the program. The program block isn't saved in system memory, and can't be preserved
upon power failure. This is called as MDI operation and the step follows:
(1) Press mode selection key [Edit];
(2) Select [Monitor], [MDI] in the menu to enter MDI interface;
(3) Enter program block instruction manually;
(4) Press [Start], [EOB] to start executing the program block.
ADTECH4 SeriesCNC Maintenance Manual

5. Automatic Operation