Adtech ADTECH4 CNC Series Maintenance Manual page 128

018
X pulse command format (restart)
Y pulse command format (restart)
Z pulse command format (restart)
4 pulse command format (restart)
B pulse command format (restart)
C pulse command format (restart)
Range
Unit
Authority
Default
Effective time
Note
019 X pulse logic direction (restart)
Y pulse logic direction (restart)
Z pulse logic direction (restart)
4 pulse logic direction (restart)
B pulse logic direction (restart)
C pulse logic direction (restart)
Range
Unit
Authority
Default
ADTECH4 SeriesCNC Maintenance Manual
function only can stop pulse in instant mode. Therefore, the instant stop
mode may cause mechanical vibration if the speed is too high. While
software scanning mode uses maximum acceleration mode and
decelerates according to the maximum acceleration set to every axis by
the user (parameter P2.029), and therefore overshot will occur.
: 0~1
: None
: Super admin
: 1
: Restart
: Pulse command format setting is to configure the mode of output pulse.
The compatible command format of the motor drive should be known in
advance.
0 Pulse + pulse
1 Pulse + direction
: 0~1
: None
: Super admin
: 1