Adtech ADTECH4 CNC Series Maintenance Manual page 105

005
IO filter level (restart)
Range
Unit
Authority
Default
Effective time
Note
006
Select communication mode (restart)
Range
Unit
Authority
Default
Effective time
Note
008
Maximum hand wheel speed (mm/min)
Range
Unit
Authority
Default
Effective time
Note
009
Hand wheel response factor
Range
Unit
Authority
Default
ADTECH4 SeriesCNC Maintenance Manual
Z phase enable switch in IO configuration parameters is enabled,
mechanical home will enable Z phase positioning as home position
automatically after signal reaches.
: 0~8
: None
: Super admin
: 0
: After restarted
: Set the filter constant;
If the environment has too much interference, e.g. rain and thunder,
please enter a filter value. Higher value indicates longer test time and
high reliability; 0 indicates no filter;
: No User Network Uart All User
: None
: Operation admin
: Uart
: Restart
:
: 500 ~ 10000
: None
: Operation admin
: 5000
: Instant
: Used to limit the maximum speed of moving the axis with hand wheel
(note: valid when P1.062 is set to 0).
: 100 ~ 3000
: None
: Operation admin
: 1000