Program Saving & Editing; Saving The Program In The Memory; Keypad Input (New Program); Pc Serial Port Input - Adtech ADTECH4 CNC Series Maintenance Manual

8.1 Saving the Program in the Memory

8.1.1.

Keypad Input (New Program)

Create new program in the memory with the keypad, and the step follows:
In the main menu, press [Edit] to enter program edit interface;
Press [File] to enter file operation interface;
Select [New] to create a new file;
Enter the file name and press [EOB] to confirm and create a new program in current directory in the
memory, and load into the system by default;
Select [Close] to exit [Edit] interface;
In edit mode, enter the program content;
After editing all programs, press [Reset] to save the edited programs into the system memory.
8.1.2.

PC Serial Port Input

The step of transmitting files to controller through PC follows:
Set system baud rate and ID No.;
Connect to PC and run Adtech serial communication software;
Set the baud rate same as controller, and scan ID device;
Select the [Upload file to NC] button in the communication software;
Select CNC file in the popup dialog box and press [Open] button.
8.1.3.

Copying Processing Files from USB Disk

The step of copying CNC processing file to system memory through USB disk follows:
In the main menu, press [Edit] to enter program edit interface;
Select [File] to enter file operation interface;
Select USB disk and press [EOB] to enter;
Move the cursor to select a CNC file and then select [Copy];
Return to the root directory, locate the PROG directory in disk D, enter the directory, and select [Paste] to
complete copying.

8.2 Reading Programs into Work Area

8.2.1.

Reading Programs from Controller into Work Area

The step of loading files from system memory into work area follows:
8. Program Saving & Editing
ADTECH4 SeriesCNC Maintenance Manual