Tool Regulator (M Series) - Adtech ADTECH4 CNC Series Maintenance Manual

In the main menu, press [Monitor], [MDI] to enter the MDI interface, select edit mode, enter program
block G55G0X0Y0 (if coordinate system G55 is selected while tool setting), press [Start], [EOB], and the tool
moves to workpiece center automatically, indicating that three points arc centered properly.
The validation steps for other tool setting methods are same.
4.6.2.

Tool regulator (M series)

Tool regulator principle:
The tool regulator uses external sensor switch to set the reference point for axis Z, which is similar to
home. After changing tool during processing or changing tool manually, transfer this function to automatically
check the Z value of current workpiece's home.
ADTECH4 SeriesCNC Maintenance Manual