Adtech ADTECH4 CNC Series Maintenance Manual page 107

Note
014
Arc interpolation feed rate
Range
Unit
Authority
Default
Effective time
Note
015
G73(M) circulating tool retraction amount
016
G83(M) circulating tool retraction amount
Range
Unit
Authority
Default
Effective time
Note
017
Arc interpolation processing mode
Range
Unit
Authority
Default
Effective time
Note
018
Speed optimization constraint mode
Range
Unit
Authority
ADTECH4 SeriesCNC Maintenance Manual
: The ID number setting of the controller when DNC or other PC software
and this controller are in MODBUS communication mode
: 0~1
: mm
: Operation admin
: 0.2
: Instant
: Set the arc interpolation equivalent
If this value is too small, the arc has higher approximation accuracy, but
the computation will be too high, making the pause during processing
obvious and affecting the processing effect.
: 0.1~100
: mm
: Operation admin
: 2.000
: Instant
: Set the tool retracting amount after Q is fed in G73 and G83 instructions;
this parameter (default: 2mm) is set according to actual chip removal
effect.
: Time split, position split
: None
: Operation admin
: Position split
: Instant
: Set the split mode of arc interpolation to position split or time split.
: Angle Speed Speed1
: None
: Operation admin