Table of Contents
Advertisement
A
E—E
M
PPENDIX
RROR
ESSAGES
Table E-1 Library error messages (continued)
Error Message
File Open Fail
File Read Fail
File Seek Fail
File Write Fail
General Failure
General HW Failure
I/E Port Disabled
P
M
RODUCT
ANUAL
242
Description
The library could not find
the file on the USB device,
or it could find the file, but
not open it.
The library could not read
the next block of data from
the USB device.
The library could not seek to
a specific offset within a USB
file.
The library could not write
the next block to the USB
file.
An operation couldn't be
completed because of an
internal problem.
An operation couldn't be
completed because of a
mechanical problem.
The requested action cannot
be done because the I/E port
is disabled.
Corrective Action
1.
Ensure that the selected file is present on the
USB device.
2.
Ensure that the USB device is securely
inserted and retry the operation.
3.
Re-write the file to the USB device and retry
the operation.
4.
Retry with another USB device.
If the error persists, contact Technical Support
(see
page
iii) or your service provider.
1.
Ensure that the USB device is securely
inserted and retry the operation.
2.
Re-write the file to the USB device and retry
the operation.
3.
Retry with another USB device.
If the error persists, contact Technical Support
(see
page
iii) or your service provider.
1.
Ensure that the USB device is securely
inserted and retry the operation.
2.
Re-write the file to the USB device and retry
the operation.
3.
Retry with another USB device.
If the error persists, contact Technical Support
(see
page
iii) or your service provider.
1.
Ensure that the USB device is securely
inserted and retry the operation.
2.
Retry the operation.
3.
Retry with another USB device.
If the error persists, contact Technical Support
(see
page
iii) or your service provider.
1.
Reset the library and retry the operation. See
page 134
for reset instructions.
2.
If the error persists, contact your service
provider.
1.
Reset the library and retry the operation. See
page 134
for reset instructions.
2.
If the error persists, contact Technical Support
(see
page
iii) or your service provider.
ƒ Determine that the I/E port should be disabled
and try a new command.
-or-
ƒ Enable the I/E port and retry the command. See
the Product Manual.
1017472
Advertisement
Chapters
Table of Contents
Troubleshooting
