Figure 7-6 Tape Drive Cooling Plate - Tandberg Data Magnum 224 Product Manual

C 7—M
HAPTER AINTENANCE
Screws (A)

Figure 7-6 Tape drive cooling plate

3. 3. 3. 3.
P M
RODUCT ANUAL
164
a. a. a. a.
Remove the two screws (
Remove the plate, and discard it and the screws.
Cooling plate
b. b. b. b. Disconnect the power cables (
Installing the tape drive—
a. a. a. a. Locate the serial cable (
it to the appropriate serial connector inside the library. Route the cables
as shown in Figure 7-2
Tape drive Quantity
Second tape drive
Half height
Single tape drive
b. b. b. b.
While holding the cables to the side, slide the new tape drive directly into
the library, leaving it a short distance out to access the cables. Use care
not to damage the cables.
) holding the tape drive cooling plate (
A
(B)
) from the installed tape drive.
P
) that came in your replacement kit and attach
S
and Figure 7-7.
Install in this
opening...
Top
Bottom
).
B
Looking inside Looking inside
back of library back of library
Retaining
tab
Single half height
tape drive (cables
removed for clarity)
Serial Internal
connector label
Top Drive 2
Bottom Drive 1
1017472