Tandberg Data Magnum 224 Product Manual page 191

4. 4. 4. 4.
5. 5. 5. 5.
6. 6. 6. 6.
7. 7. 7. 7.
R
1. 1. 1. 1.
2. 2. 2. 2.
! ! ! !
A 2007
UGUST
Note: The library lists "no drive" only if there is no room for more tape
drives. For example, in the above screen, the library has one half
height tape drives. The two tape drive number is for two half height
tape drives.
Press Modify. Press
desired configuration. Press Select.
Select Drive 1
HP LTO HalfHigh
TANDBERG LTO HH
IBM LTO FullHigh
Notes: This menu option requires input for all of the tape drives installed in
the library. If you press "Back" before configuring all the tape drives,
the configuration selection will not change.
Press OK.
Repeat the process for each tape drive installed.
Press Back (as needed) to return to the Home screen.
O
ESUMING PERATION
Power the library off (Press the 0 on the back of the unit—after setting the
new tape drive configuration).
Connect the interface cables.
a. a. a. a.
Connect the Fibre Channel cable (or cables if you installed more than one
Fibre Channel tape drive).
or...
b. b. b. b.
Connect the SCSI cable (or cables if you installed more than one tape
drive) and a terminator (if needed).
LTO-2, LTO-3, and LTO-4 SCSI tape drives require an Ultra 3
Important
or LVD 160 terminator to function properly on the SCSI bus.
An inadequate terminator will result in various SCSI bus issues,
including bus hangs and Read/Write failures. See
Fails with Sporadic Errors" on page
M
AGNUM
R L
ECONFIGURING THE IBRARY AND
or until the selection arrow (
Select
224, S L T24,
TORAGE IBRARY OR
R O
ESUMING PERATION
) points to the
Back
"Tape Drive
197.
S L 2U
TORAGE OADER
173