Tandberg Data Magnum 224 Product Manual page 178

C 7—M
HAPTER AINTENANCE


Warning
Warnung
Advertencia
G
The library accommodates Ultrium 4 (LTO-4), Ultrium 3 (LTO-3), or Ultrium 2
(LTO-2) tape drives and both half height (HH) and full height (FH)
configurations. The library does not accommodate LTO-1 tape drives.
Note:
P M
RODUCT ANUAL
160
disconnect the Ethernet cable from the back of the library.
Obtain these items—a #2 Phillips screwdriver and a small flat-blade
screwdriver.
Ensure that the environment is free of conditions that could cause
electrostatic discharge (ESD)—If possible, use an antistatic mat and a
grounded static protection wristband during installation. If a mat and
wristband are not available, touch a known grounded surface, such as a
computer's metal chassis.
Before performing any installation or maintenance procedures, be sure that
the library's power switch is off and that the power cord is disconnected
from the library and the outlet.
Vor der Ausführung von Installations- oder Wartungsarbeiten ist darauf zu
achten, daß der Library-Netzschalter auf "Aus" gestellt ist und daß das
Anschlußkabel vom Library und der Steckdose entfernt ist.
Antes de realizar cualquier procedimiento de instalación o de
mantenimiento, comprobar que el interruptor de alimentación de la
biblioteca está apagado y que el cable de alimentación no está enchufado
ni a la biblioteca ni a la toma de corriente.
I
ENERAL NFORMATION
! ! ! ! The tape drives must be specially configured (at the factory) for
Important
use in a Tandberg Data library. Purchase tape drive kits only from
Tandberg Data or Tandberg Data-approved suppliers.
To view this information...
Adding a second half height tape drive
Replacing a tape drive with the same configuration
(half height -to- half height or full height -to- full height)
Replacing a half height tape drive with a full height tape drive
Reconfiguring the library
(this step must be completed for the library to
Resuming operation
Confirming the installation
Most of the illustrations show SCSI configurations. Use the same steps to
install Fibre Channel tape drives.
go to...
page 163
page 165
page 169
page 172
operate)
page 173
page 174
1017472