Replacing A Tape Drive (Half Height To Full Height) - Tandberg Data Magnum 224 Product Manual

4. 4. 4. 4.
! ! ! !
R T
EPLACING A APE
To replace the half height tape drive in your library (or both half height tape
drives) with a full height tape drive, follow these steps.
1. 1. 1. 1.
A 2007
UGUST
Completing the installation—
a. a. a. a. Attach the SCSI cover plate and the tape drive cover plate that came with
your replacement kit. See
Tape drive Quantity
Second tape drive
Half height
Single tape drive
Full height Single tape drive
The library requires both the SCSI cover plates and the tape
Important
drive cover plates for ESD protection. Do not leave any
openings uncovered.
Do not connect the SCSI cables until after you reconfigure the
library.
b. b. b. b. Reconfigure your library—You must reconfigure your library for your
backup application to recognize the new tape drive. See
instructions.
D (H
RIVE ALF HEIGHT TO
Preparing for replacement—
a. a. a. a.
Power off the host.
b. b. b. b. Power off the library (press the 0 on the back of the unit).
c. c. c. c. Disconnect the power cord, the SCSI or Fibre Channel cable(s), and the
terminator (if present).
M
AGNUM
R T D
EPLACING A APE RIVE
"Reference Illustrations" on page
Install in this
opening...
Top
Bottom
Bottom
F
ULL HEIGHT
224, S L T24,
TORAGE IBRARY OR
(H F
ALF HEIGHT TO ULL HEIGHT
161.
Serial Internal
connector label
Top Drive 2
Bottom Drive 1
Bottom Drive 1
page 172 for
)
S L 2U
TORAGE OADER
169
)